|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
#1
12-21-2004, 08:49 AM
|
||||
|
||||
High or Low Level Inputs - EL8A
I have an Alpine 9827 receiver that has subwoofer outputs. The specs. are 4V/10K ohms. I assume this is a low level output and should be connected to the low level inputs of the Bazooka?
In your manual you advise to use the high level inputs even if I have the low level outputs. What difference will this make? Are the high level the direct speaker outputs from the receiver (I am not using an external amplifier) and if so would I wire the Bazooka inputs in parallel with the other speakers? Thanks. Reagrds, Richard 
|
|
#2
12-21-2004, 05:51 PM
|
||||
|
||||
|
Read this thread http://www.bazooka.com/forum/topic.asp?TOPIC_ID=827. Not only should it answer your question but it's also informative.
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| no rca or high level inputs | barrwidabarr | Component Amplifiers | 4 | 05-18-2005 09:35 AM |
| High/low level inputs - need help | xecuter2 | General Chat | 1 | 02-16-2005 11:10 AM |
| RCA OR High Level Inputs | Redman44 | Amplified Tube Subwoofers | 7 | 02-01-2005 04:51 PM |
| High Level Vs Low Level Inputs | edjof17 | Amplified Tube Subwoofers | 5 | 11-24-2002 12:04 AM |
| High Level v/s Low Level Inputs | djwrightson | Amplified Tube Subwoofers | 1 | 09-12-2002 08:54 AM |
All times are GMT -5. The time now is 04:07 AM.