|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
#1
11-10-2003, 02:51 PM
|
||||
|
||||
Newbie Install Question
Hi guys...I'm new to installations and have a pretty basic question. I just purchased a Panasonic CQ-DP103U with one Pre-amp output-Rear(no subwolfer out). In looking at the Bazooka manual and it says to use a lowlevel connection to the RCA jacks, which I'm assuming is a subwolfer out. Is this correct? Can I not use my standard Pre-Amp output to an amplified tube? Is there anything else I need to be aware of? Thanks in advance!
|
|
#2
11-11-2003, 04:35 PM
|
||||
|
||||
|
You can use a rear in place of the sub out if you don't have one and it'll work just fine. Only problem is that then you adjust the sub by fading from front to rear so you can't adjust the sub level independently of the rear speakers.
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| newbie question | lilwoedi | Amplified Tube Subwoofers | 1 | 04-05-2007 01:09 PM |
| NEWBIE QUESTION | saturn | Amplified Tube Subwoofers | 2 | 09-18-2006 12:36 PM |
| Newbie connector question... | thespecialistkc | Amplified Tube Subwoofers | 1 | 04-18-2005 10:12 AM |
| Please help - quick newbie install question! | Newbiezooka | Amplified Tube Subwoofers | 4 | 01-06-2004 04:46 PM |
| newbie question.. channels | philoader | Component Amplifiers | 8 | 02-09-2003 03:18 AM |
All times are GMT -5. The time now is 10:05 PM.