BTA6100 won't turn on

minshik · #1 03-20-2011, 03:51 AM

I have a 2009 Honda Fit with the factory HU and I have used a FAST connector to connect the sub to the HU. I believe the wiring is correct, but when I turn on the ignition, the green indicator light flickers and then turns off. The sub does not work. Any thoughts?

heavyduty · #2 03-20-2011, 05:11 PM

Quote:

Originally Posted by minshik

I have a 2009 Honda Fit with the factory HU and I have used a FAST connector to connect the sub to the HU. I believe the wiring is correct, but when I turn on the ignition, the green indicator light flickers and then turns off. The sub does not work. Any thoughts?

Welcome to the Bazooka Forum. Check your ground connection, make sure that the surface has been properly prepared and securely fastened.

minshik · #3 03-20-2011, 07:25 PM

Quote:

Originally Posted by heavyduty

Welcome to the Bazooka Forum. Check your ground connection, make sure that the surface has been properly prepared and securely fastened.

I checked the ground connection and all other connections with a meter. All levels say that it's ok. Are there any other options? Could it be that the subwoofer is defective?

heavyduty · #4 03-20-2011, 07:59 PM

Quote:

Originally Posted by minshik

I checked the ground connection and all other connections with a meter. All levels say that it's ok. Are there any other options? Could it be that the subwoofer is defective?

Did you measure your resistance at ground? If your using the FAST-9999 make sure that all connections at the headunit are tight and secure.

minshik · #5 03-21-2011, 12:10 AM

Quote:

Originally Posted by heavyduty

Did you measure your resistance at ground? If your using the FAST-9999 make sure that all connections at the headunit are tight and secure.

Yes I measured the resistance at ground. i checked all the connections at the HU and they are all in contact.

heavyduty · #6 03-21-2011, 08:30 AM

Quote:

Originally Posted by minshik

Yes I measured the resistance at ground. i checked all the connections at the HU and they are all in contact.

What color are the wires you are connecting to at the factory harness?

minshik · #7 03-21-2011, 09:13 PM

Coooll it works now! Thank you so much.

heavyduty · #8 03-21-2011, 10:05 PM

Quote:

Originally Posted by minshik

Coooll it works now! Thank you so much.

Anytime, this is what the Bazooka Forum is for. Please post back with any other comments or questions you may have.