Originally Posted by punjistick
Just installed another bta50fh, and I'm not getting much volume out of it. I previously installed one in my daughters car and it sounded so good I bought one for my Wife's.
Phase is good, ground is good, power is good, but I'm not getting enough out of it to even tell it's installed. The one in my daughter's car works like a champ. Even switched them and it still doesn't make a difference.
Installation is in a 2013 Honda Accord. I've disconnected the active noise cancellation module and ensured polarity is correct. Power and switch are run from the fuse block via "add a fuse" fast taps.
Anyone have any tips?
Are you connected to the front or rear speakers of the Accord?