Quote:
Originally Posted by J.lafriend
Hi,
I checked all connections in the wiring path, all are good. The problem is when the volume is increased, around the lower twenties on the Kenwood, which is about less then half, the BTA 10250D stops working. ( trips, clips). Turning the car off and on resets the tube. Is this a defective tube, as I used the same Kenwood with a BTA 8100FHC with no problems.
Any thoughts on this ?
|
By checking your power and ground connections first you are eliminating them as a culprit.
When you had the BTA8100 connected were you using the High Level or Low Level Inputs?