View Single Post
  #2  
Old 01-05-2013, 02:22 PM
heavyduty's Avatar
heavyduty heavyduty is offline
Super Moderator
 
Join Date: Jan 2008
Posts: 2,921
Thanks: 347
Thanked 758 Times in 679 Posts
Groans: 0
Groaned at 0 Times in 0 Posts
Reputation: 768
heavyduty is a splendid one to beholdheavyduty is a splendid one to beholdheavyduty is a splendid one to beholdheavyduty is a splendid one to beholdheavyduty is a splendid one to beholdheavyduty is a splendid one to beholdheavyduty is a splendid one to behold
Default Re: Help with BTA 10250D

Quote:
Originally Posted by J.lafriend View Post
Hello,
I have installed a BTA 10250D using the line level outputs from a Kenwood DPX 308U receiver and upgraded wiring as required in a 2008 Pontiac Vibe. The BTA powers up when the Kenwood is turned on and continues to work until the volume is increased to " normal " listening levels. ( Approximately 20 on the Kenwood ) At this level the BTA stops working. The level input on the BTA is set to the lowest level and will reset after the car is turned off. I used the same Kenwood unit with a BTA 8100FHC with no issues. Any thoughts on why this is happening would be appreciated.
Can you explain the upgraded wiring?
__________________
power your system down
Reply With Quote