View Single Post
  #6  
Old 12-01-2012, 09:31 AM
heavyduty's Avatar
heavyduty heavyduty is offline
Super Moderator
 
Join Date: Jan 2008
Posts: 2,950
Thanks: 351
Thanked 771 Times in 690 Posts
Groans: 0
Groaned at 0 Times in 0 Posts
Reputation: 781
heavyduty is a splendid one to beholdheavyduty is a splendid one to beholdheavyduty is a splendid one to beholdheavyduty is a splendid one to beholdheavyduty is a splendid one to beholdheavyduty is a splendid one to beholdheavyduty is a splendid one to behold
Default Re: Can i bridge my bt10250d

Quote:
Originally Posted by Jade_monkey07 View Post
Everything is wired negative to negative, positive to positive, i will try the front speakers this morning(wont take me 15 min). I think its a combination of terrible speakers(if i turn the bass up past zero on the factory deck they sound like ****) and no separate control for the sub.
Im going to look at aftermarket decks today.
What difference would a 2.5v volt pre amp or 4 volt make in this sub/amp? Cleaner signal is what the word around the web is, but is there actually a difference in volume at all? since the amp is starting with more voltage i would imagine so. I dont think its worth the extra 150-200 dollars...
Little to none. Using the high level inputs, you have balanced architecture. Everyone for the past couple of years has been raving about balanced input. Bazooka realized the important noise rejecting capabilities of balanced inputs years ago. Using the low level inputs doesn't always provide sufficient voltage to drive the Bazooka to full output. Some radios simply have too weak of output on the RCA's to get full output.

If you want control over the Tube, purchase the correct RBCM and save some cash over purchasing a new headunit.
__________________
power your system down
Reply With Quote