View Single Post
  #26  
Old 03-02-2011, 12:13 PM
ldtzbme's Avatar
ldtzbme ldtzbme is offline
Just Gettin Started
 
Join Date: Feb 2011
Posts: 8
Thanks: 0
Thanked 1 Time in 1 Post
Groans: 0
Groaned at 0 Times in 0 Posts
Reputation: 11
ldtzbme is on a distinguished road
Default Re: bazooka tube identification

hey heavyduty it seems i have another question....the owners manual for the bta6250d says it recomends using speaker level inputs. Then it says if the source unit has both front and rear speaker outputs, use only one set of speaker outputs, but then goes on to explain where to connect the green and green w/black stripe, and the gray and gray w/black stripe. So my question is ...this is basicly saying that i can connect these wires directly to my stereo's wiring harness(either front left and right or rear left and right)even though the front and rear door speakers are wired to these? I thought if you wired multiple speakers together it changes the ohm load. Also, if i do this, i'm pretty sure the sub out function on my stereo will not apply, but what about if i got the RBCM-250D remote control module...would that work?
Reply With Quote