Go Back   Club Bazooka > Search Forums

Notices

Showing results 1 to 25 of 500
Search took 0.22 seconds.
Search: Posts Made By: heavyduty
Forum: Amplified Tube Subwoofers 07-22-2014, 09:35 AM
Replies: 1
Views: 65
Posted By heavyduty
Re: C5 Corvette

It is a bit more complicated, but very possible. In this install, due to the unique voltage of the Bose System, the RCA's of the harness, either the FAST System, or the harness with a BTAXX100, will...
Forum: Amplified Tube Subwoofers 07-21-2014, 03:39 PM
Replies: 3
Views: 88
Posted By heavyduty
Re: Wiring Harness Diagram.....

Follow the instructions on the FAST-9999 installation sheet.

http://www.bazooka.com/pdf/current/FAST_9999_instr_rev1_sm.pdf
Forum: Amplified Tube Subwoofers 07-13-2014, 01:06 AM
Replies: 3
Views: 89
Posted By heavyduty
Re: Stock 2004 Toyota Matrix Stereo

Consult the owner's manual of your Pyle for installation requirements.
Forum: Amplified Tube Subwoofers 07-13-2014, 01:05 AM
Replies: 5
Views: 91
Posted By heavyduty
Re: Wire Gauge??

I have no idea, as you are using a Pyle component. I have no information on the unit. However, the owner's manual of the Pyle, should have an appropriate wire size to use.
Forum: Amplified Tube Subwoofers 07-13-2014, 01:02 AM
Replies: 9
Views: 250
Posted By heavyduty
Re: Distorted/Muffled Base HELP

Several things. The first being, where in the fuse box are you located? The second, finding out where the remote turn-on is attached? It is critical that these answers are discovered. And...
Forum: Marine Audio 07-13-2014, 12:58 AM
Replies: 2
Views: 104
Posted By heavyduty
Re: Tube location

As long as the Tube is corner loaded, and there is a vent, it will sound amazing. You will be very pleased with the performance.

A word of caution, before you start cutting holes, see how the...
Forum: Amplified Tube Subwoofers 07-09-2014, 03:08 PM
Replies: 5
Views: 91
Posted By heavyduty
Re: Wire Gauge??

That would be largely dependent on power output, as well as total length.
Forum: Amplified Tube Subwoofers 07-08-2014, 03:46 PM
Replies: 5
Views: 91
Posted By heavyduty
Re: Wire Gauge??

That will be dependent on what model Tube you decide to use. As for the second question, are you referring to the wire that you will be using from the amplifier to the speaker?
Forum: Amplified Tube Subwoofers 07-08-2014, 03:44 PM
Replies: 3
Views: 89
Posted By heavyduty
Re: Stock 2004 Toyota Matrix Stereo

No, the factory single, 6 disc changer, or JBL system, have no RCA outputs. You will need to identify the correct wires and use the front speakers for your signal connection.
Forum: Amplified Tube Subwoofers 07-03-2014, 11:27 AM
Replies: 9
Views: 250
Posted By heavyduty
Re: Distorted/Muffled Base HELP

How and where are the constant +12v power, switched +12v power, and the ground connected?
Forum: Amplified Tube Subwoofers 07-03-2014, 11:24 AM
Replies: 3
Views: 66
Posted By heavyduty
Forum: Amplified Tube Subwoofers 07-03-2014, 07:46 AM
Replies: 3
Views: 66
Posted By heavyduty
Re: bta8100 in my jeep factory system

Have you identified the factory harness? If so, can you list the color of the wires in the harness?
Forum: Amplified Tube Subwoofers 06-21-2014, 10:38 PM
Replies: 1
Views: 125
Posted By heavyduty
Re: Any idea why ?

The RS Series ouptut was 80 watts (120 watts when paired with a slave unit), and the RSA-hp was 150 watts.

On to your original question, one, there is the difference in woofer size. Two, the...
Forum: Amplified Tube Subwoofers 06-20-2014, 09:35 AM
Replies: 4
Views: 2,114
Posted By heavyduty
Re: Jeep Wrangler

What factory sound system do you have?
Forum: Amplified Tube Subwoofers 06-20-2014, 09:34 AM
Replies: 9
Views: 250
Posted By heavyduty
Re: Distorted/Muffled Base HELP

That sounds like an ignition issue, especially due to the fact that it happens when the car is off. What type of vehicle is the Tube installed in, as well as any modifications, specifically with...
Forum: Amplified Tube Subwoofers 06-20-2014, 09:33 AM
Replies: 1
Views: 76
Posted By heavyduty
Re: 100W Amp/tube staying on

The remote turn-on wire needs to be relocated to a switched +12v source. If Best Buy did the install, then Best Buy will and should fix this at no cost. If there is no switched +12v source, for...
Forum: Amplified Tube Subwoofers 06-13-2014, 09:26 PM
Replies: 1
Views: 103
Posted By heavyduty
Re: BTA850FH install ??

Take a look at your ground connection. If the ground is not adequate, you will pick up a transient thump. If ground checks out, move to your connections, and make sure the RCA's are fully inserted.
Forum: Amplified Tube Subwoofers 06-04-2014, 03:52 PM
Replies: 4
Views: 165
Posted By heavyduty
Re: Can you identify this model?

Purchase a FAST-9999 and FAST-BTAH. Everything will connect to the factory headunit and you will be up and rolling. Make a proper ground, mount the Tube, and enjoy those beats.
Forum: Amplified Tube Subwoofers 06-02-2014, 03:57 PM
Replies: 12
Views: 468
Posted By heavyduty
Re: help with install?

Nope. The only time the fuse will blow is when there is a problem, such as direct short to ground, indicating something is seriously wrong.

Relax and enjoy those lows.
Forum: Amplified Tube Subwoofers 06-01-2014, 10:07 AM
Replies: 12
Views: 468
Posted By heavyduty
Re: help with install?

No. It will not fry your headunit. Your headunit is not powering the Tube, period. All you have done is connected to a power source, just like plugging a cord into a wall outlet. It really is...
Forum: Amplified Tube Subwoofers 05-31-2014, 09:47 AM
Replies: 1
Views: 128
Posted By heavyduty
Re: bta10250d installation process?

There is nothing interchangeable between the two lines. The BTAXX50/100 series are the only ones that can be used with the FAST Harness System.

Google 2008 Ford Escape headunit removal and you...
Forum: Customer Service 05-29-2014, 10:43 AM
Replies: 3
Views: 131
Posted By heavyduty
Forum: Customer Service 05-28-2014, 05:36 PM
Replies: 3
Views: 131
Posted By heavyduty
Re: hooked up my bazooka and now the deck wont turn on :(

The headunit will not turn on, or, the cd player does not work?
Forum: Amplified Tube Subwoofers 05-17-2014, 10:56 AM
Replies: 12
Views: 468
Posted By heavyduty
Re: help with install?

No. For two reasons. If the Tube is connected correctly, the only time the Tube in "on," is when the headunit is on.

The harness and wattage have nothing to do with amperage draw. The...
Forum: Amplified Tube Subwoofers 05-15-2014, 08:27 PM
Replies: 12
Views: 468
Posted By heavyduty
Re: help with install?

No, you do not need to drill a hole in the firewall, or, attach to the positive terminal of the battery. Follow the instructions on the FAST-9999 to connect to the vehicle's headunit, make the...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -5. The time now is 11:16 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Template-Modifications by TMS
bazooka.com
SAS, BAZOOKA, BASS TUBES, and LISTEN TO YOUR EARS are registered trademarks of Southern Audio Services, Inc.