Go Back   Club Bazooka > Search Forums

Notices

Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: heavyduty
Forum: Passive Tube Subwoofers Yesterday, 02:41 PM
Replies: 1
Views: 9
Posted By heavyduty
Re: what is optimal low pass frequency

Optimal is 90hz, and adjust down from there. However, since you do not have that available, start at 100hz. I say optimal, as 90Hz is the maximum frequency before bass begins to become directional....
Forum: Amplified Tube Subwoofers 05-12-2015, 09:01 AM
Replies: 6
Views: 95
Posted By heavyduty
Re: New tube BTA6250D shows no power

Contact customer Service and they will issue you a RA#
Forum: Amplified Tube Subwoofers 05-12-2015, 08:07 AM
Replies: 6
Views: 95
Posted By heavyduty
Re: New tube BTA6250D shows no power

What pins are you using to verify power and remote on the Tube's 14 pin connector?
Forum: Amplified Tube Subwoofers 05-11-2015, 11:15 AM
Replies: 6
Views: 95
Posted By heavyduty
Re: New tube BTA6250D shows no power

What inputs are you using for your signal source?
Forum: Amplified Tube Subwoofers 05-06-2015, 09:06 PM
Replies: 5
Views: 151
Posted By heavyduty
Re: Powered Subwoofer Wiring

What owner's manual do you have? Yes, connect both sets of the Tube's high-level inputs to the signal source.
Forum: Amplified Tube Subwoofers 05-04-2015, 09:26 PM
Replies: 5
Views: 151
Posted By heavyduty
Re: Powered Subwoofer Wiring

Thoughts? Absolutely, and it is an easy fix. If you are connected to a speaker, like a tweeter, that has no bass information present, what is the Tube supposed to reproduce?

The owner's manual...
Forum: Amplified Tube Subwoofers 05-04-2015, 12:46 PM
Replies: 5
Views: 151
Posted By heavyduty
Re: Powered Subwoofer Wiring

Nope. You are not doing anything by connecting to the speakers, other than producing a signal source. You are not powering the Tube, again, only creating a signal source from this location. Check...
Forum: Marine Audio 04-29-2015, 02:56 PM
Replies: 1
Views: 82
Posted By heavyduty
Re: MARINE MA475D (Speaker connecting terminals)

You are seriously over thinking this. Feel free to use any type of stranded copper wire. These terminals are usually made out of brass.
Forum: Component Amplifiers 04-29-2015, 02:52 PM
Replies: 1
Views: 87
Posted By heavyduty
Re: bazooka 200 watt csa 50.2

300 watts is the max power rating, and it really doesn't mean anything as far as output. Wire each speaker in parallel, and connect to each channel. A 2 ohm stereo load is equal to the bridged...
Forum: General Chat 04-14-2015, 08:31 AM
Replies: 6
Views: 296
Posted By heavyduty
Re: mounting tube

My first suggestion is to run like hell. At the very minimum, you are looking at potential port noise, from the screws in the port area. However, that is one piss poor way of mounting anything. ...
Forum: Amplified Tube Subwoofers 04-14-2015, 08:26 AM
Replies: 3
Views: 170
Posted By heavyduty
Forum: Amplified Tube Subwoofers 04-13-2015, 07:45 PM
Replies: 3
Views: 170
Posted By heavyduty
Re: Bta250d turns on once, then needs unplugged before next use

Yes, and it is an easy fix. You are running into an impedance problem using the factory sub for a signal input. Install an LOC and the problem will disappear. Find one that has a trigger output...
Forum: Amplified Tube Subwoofers 04-06-2015, 01:38 PM
Replies: 3
Views: 544
Posted By heavyduty
Re: Mounting the tube my way!

Vertical performance will be fine. In fact, no different than a proper corner loading, horizontal position.
Forum: Amplified Tube Subwoofers 04-06-2015, 01:37 PM
Replies: 3
Views: 544
Posted By heavyduty
Re: Mounting the tube my way!

Mounting the Tube vertically, mimics the correct way to install. Instead of firing towards the taillights or the side of the vehicle, you are firing it into the floor which is like one big corner. ...
Forum: General Chat 03-26-2015, 01:04 PM
Replies: 6
Views: 296
Posted By heavyduty
Re: mounting tube

Take a look at how you have them fastened. Many times, the straps are unable to securely fasten the Tube, as the way the strap is positioned in the buckle, will not allow the strap to tighten, or...
Forum: Customer Service 03-24-2015, 11:41 AM
Replies: 1
Views: 125
Posted By heavyduty
Re: BT Series 12"

I don't think the problem is with the Tube. You should check out the amplifier, as well as the power and ground wires.
Forum: General Chat 03-23-2015, 09:13 AM
Replies: 6
Views: 296
Posted By heavyduty
Re: mounting tube

I find using the mounting bases and straps, seem to work really well.
Forum: Amplified Tube Subwoofers 03-18-2015, 10:23 AM
Replies: 188
Views: 62,236
Posted By heavyduty
Re: FAST-9999 Installaton Instructions

It is rare, but it does happen. Enjoy those low's.
Forum: Passive Tube Subwoofers 03-18-2015, 08:43 AM
Replies: 2
Views: 211
Posted By heavyduty
Re: Help with Bazooka NOS8

How about this, for an answer? Is it an ideal way? No, absolutely not.

Let's begin with your signal source. By powering the NOS8, off of the right rear speaker, you have changed the impedance...
Forum: Amplified Tube Subwoofers 03-18-2015, 08:37 AM
Replies: 6
Views: 219
Posted By heavyduty
Re: Trouble with grounding (maybe)

You are still dealing with an installation issue. You have a less than adequate ground connection, and you obviously have a issue with either the location, or installation, of your in-line fuse...
Forum: Amplified Tube Subwoofers 03-13-2015, 01:39 PM
Replies: 188
Views: 62,236
Posted By heavyduty
Re: FAST-9999 Installaton Instructions

Have you tried disconnecting the left speaker wires from the FAST-9999, and connecting the right speaker wires of the FAST-9999 only, to the left speaker?
Forum: Amplified Tube Subwoofers 03-13-2015, 11:25 AM
Replies: 188
Views: 62,236
Posted By heavyduty
Re: FAST-9999 Installaton Instructions

If you have tried the right rear speaker, and are thinking about using the right front, where is the connection made now?
Forum: Amplified Tube Subwoofers 03-13-2015, 10:47 AM
Replies: 188
Views: 62,236
Posted By heavyduty
Re: FAST-9999 Installaton Instructions

No, it is not normal, and is an indication that something with your install is wrong.

Have you correctly identified the wires in the factory harness? Have you connected the left inputs to the...
Forum: Amplified Tube Subwoofers 03-11-2015, 05:07 PM
Replies: 6
Views: 219
Posted By heavyduty
Re: Trouble with grounding (maybe)

No, I have never heard of a ground going bad over time. A ground wire that is sufficiently prepped and connected, will only go bad if something breaks, such as a terminal, or the ground wire gets...
Forum: Amplified Tube Subwoofers 03-11-2015, 02:07 PM
Replies: 6
Views: 219
Posted By heavyduty
Re: Trouble with grounding (maybe)

First, let me ask, how are you preparing the connection for the ground? How are you prepping the area? Second, how are you connecting the ground wire, to the ground bolt? What kind of terminal? ...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -5. The time now is 05:11 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
Template-Modifications by TMS
bazooka.com
SAS, BAZOOKA, BASS TUBES, and LISTEN TO YOUR EARS are registered trademarks of Southern Audio Services, Inc.