Go Back   Club Bazooka > Search Forums

Notices

Showing results 1 to 25 of 29
Search took 0.01 seconds.
Search: Posts Made By: fdm813
Forum: Component Amplifiers 08-04-2004, 09:05 PM
Replies: 6
Views: 1,065
Posted By fdm813
I just read the owners manual for my EL2150. It...

I just read the owners manual for my EL2150. It shows the Aux input for a tube. I assume you plug your tube into the socket provided. It might be to your advantage to give the techs at Bazooka a call...
Forum: Component Amplifiers 08-03-2004, 11:46 PM
Replies: 6
Views: 1,065
Posted By fdm813
Sure it will drive them. Just don't expect bone...

Sure it will drive them. Just don't expect bone shaking bass.
Forum: Component Amplifiers 08-02-2004, 04:40 AM
Replies: 4
Views: 707
Posted By fdm813
Ok, Thanks<img src=icon_smile_big.gif border=0...

Ok, Thanks<img src=icon_smile_big.gif border=0 align=middle>
Forum: Component Amplifiers 07-31-2004, 08:00 PM
Replies: 4
Views: 707
Posted By fdm813
ELA-BCM

Does this control the gain of the amp or the bass boost?
Forum: Raw Woofers 07-28-2004, 07:52 PM
Replies: 2
Views: 794
Posted By fdm813
I'm a bit confused. First, the P.Miller 12 is a...

I'm a bit confused. First, the P.Miller 12 is a DVC woofer with 2 4 ohm coils. If you have 2 of them, how did you wire them to come up with 2 ohms? Second, you stated that it sounds good to you. Then...
Forum: Raw Woofers 07-28-2004, 07:22 PM
Replies: 9
Views: 1,641
Posted By fdm813
The Velodyne CHT15, has 300rms.

The Velodyne CHT15, has 300rms.
Forum: Component Amplifiers 07-25-2004, 06:52 AM
Replies: 7
Views: 1,207
Posted By fdm813
Many, many years ago I ran two sets of co-ax and...

Many, many years ago I ran two sets of co-ax and a sub off of one Rockford Punch 45. It can be done, but you have to use a bunch of coils and chokes to cut off freq. Also, when doing the "tri mode"...
Forum: Raw Woofers 07-25-2004, 05:49 AM
Replies: 9
Views: 1,641
Posted By fdm813
I got it together, after a 5 hour break in...

I got it together, after a 5 hour break in period, listening to "C" jazz on XM Radio (channel 71), at moderate listening levels, I popped in the movie U-571. Pretty impressive! I am useing the...
Forum: Raw Woofers 07-13-2004, 11:45 AM
Replies: 9
Views: 1,641
Posted By fdm813
My reason for selecting a sealed enclosure was...

My reason for selecting a sealed enclosure was because of the smoother roll off. With a sealed I am not limited to the tuning freq. of the port. I'll let you know how it turns out.
Forum: Raw Woofers 07-12-2004, 02:53 PM
Replies: 9
Views: 1,641
Posted By fdm813
For the Home

I am putting together a small home theater system. I have a ELW1014, that I am going to put in a .66 cu.ft. enclosure, powered by a 200watt at 4ohm plate amp. What kind of low end response can I...
Forum: Component Amplifiers 07-08-2004, 08:38 PM
Replies: 7
Views: 1,260
Posted By fdm813
I found one at www.cardomain.com , Thanks anyway.

I found one at www.cardomain.com , Thanks anyway.
Forum: Component Amplifiers 07-01-2004, 12:09 PM
Replies: 7
Views: 1,260
Posted By fdm813
Will do. Thanks

Will do. Thanks
Forum: Component Amplifiers 07-01-2004, 10:33 AM
Replies: 7
Views: 1,260
Posted By fdm813
Great, so do I order through you guys or try my...

Great, so do I order through you guys or try my local retailer, which I am sure they will have to order?
Forum: Component Amplifiers 07-01-2004, 08:15 AM
Replies: 7
Views: 1,260
Posted By fdm813
Remote Control

Is the bass remote adjustment still available. I have a EL2150 powering two RSW1024DVC in a sealed box (.66 cu ft per side). Thanks.
Forum: Raw Woofers 05-24-2003, 10:58 AM
Replies: 5
Views: 1,580
Posted By fdm813
http://www.bazooka.com/productAutoRawWoofersRS.asp...

http://www.bazooka.com/productAutoRawWoofersRS.asp?id=164
They say .56 cuft for sealed, but I think it would sound better in a larger enclosure, say 1 cuft. The ported is 1.4 cu ft. Your choice.
Forum: Raw Woofers 05-24-2003, 10:31 AM
Replies: 13
Views: 1,167
Posted By fdm813
I use a el2100 powering 2 RSW1024DVCs in a 2cu ft...

I use a el2100 powering 2 RSW1024DVCs in a 2cu ft sealed enclosure. I wired the coils in series then paralleled the the two 8 ohm loads for a safe 4ohm signal to the amp, which is running bridged. A...
Forum: Component Amplifiers 05-03-2003, 06:11 PM
Replies: 14
Views: 2,221
Posted By fdm813
novice21, Good luck on getting a reply...

novice21,
Good luck on getting a reply from BASSTECH. It would seem that they monitor the forum but are very picky about responding to a reply to one of there posts. Kinds leaves you...
Forum: Component Amplifiers 05-02-2003, 02:22 PM
Replies: 14
Views: 2,221
Posted By fdm813
I have been "into" car audio since 1980. I guess...

I have been "into" car audio since 1980. I guess the old school "facts" are not as clear cut as they used to be. So are you saying it's better to use high level inputs? Or. if its easier, it's ok to...
Forum: Component Amplifiers 05-02-2003, 03:13 AM
Replies: 14
Views: 2,221
Posted By fdm813
I take it you are refurring to speaker outputs...

I take it you are refurring to speaker outputs (high level). If this is the case, the amp converts this to a low level (pre amp)input. It is always better to use the pre amp outputs on your receiver....
Forum: Raw Woofers 04-30-2003, 08:37 AM
Replies: 9
Views: 1,169
Posted By fdm813
You are so right. It's all about the music. Not...

You are so right. It's all about the music. Not trying to impress everyone with earthshaking decibles.
Forum: Raw Woofers 04-29-2003, 12:01 PM
Replies: 9
Views: 1,169
Posted By fdm813
True, you can hear 3db difference. My point is,...

True, you can hear 3db difference. My point is, do not expect the output to be twice as loud by haveing twice the power.
Forum: Raw Woofers 04-29-2003, 01:03 AM
Replies: 9
Views: 1,169
Posted By fdm813
Be careful. You must wire the two coils in SERIES...

Be careful. You must wire the two coils in SERIES to create a 4ohm load then parallel the two subd to create the 2ohm load your looking for. REMEMBER series on the coils. BTW/ There is only 3db...
Forum: Raw Woofers 04-28-2003, 12:37 PM
Replies: 10
Views: 1,052
Posted By fdm813
I use a 2cu ft sealed box (1cuft per side) and it...

I use a 2cu ft sealed box (1cuft per side) and it does a good job.
Forum: Raw Woofers 04-28-2003, 12:13 AM
Replies: 9
Views: 1,169
Posted By fdm813
Why not wire the coils in series, creating a 8ohm...

Why not wire the coils in series, creating a 8ohm load, then wire the subs in parallel. This would give you a 4ohm load for your amp. I doubt if you would hear any differance. Also it is less strain...
Forum: Raw Woofers 04-28-2003, 12:01 AM
Replies: 0
Views: 407
Posted By fdm813
A bit confusing

I have noticed that the TVB-141 has sensitivity rating of 104DB but the RX-T1 has a sensitivity of 85DB. I thought it was the same woofer. That is huge differance. What gives? Is it a typo? Just...
Showing results 1 to 25 of 29

 
Forum Jump

All times are GMT -5. The time now is 08:12 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Template-Modifications by TMS
bazooka.com
SAS, BAZOOKA, BASS TUBES, and LISTEN TO YOUR EARS are registered trademarks of Southern Audio Services, Inc.