Go Back   Club Bazooka > Search Forums

Notices

Showing results 1 to 25 of 500
Search took 0.58 seconds.
Search: Posts Made By: heavyduty
Forum: Amplified Tube Subwoofers Today, 10:50 AM
Replies: 1
Views: 6
Posted By heavyduty
Re: Harley Street Glide Powered Tube Install

No, you will not need to add a capacitor. The amperage draw of the BTA6100 is quite low.

Be sure to check out the FAST-HD-SIK for the installation and mounting of the Tube. It will also take...
Forum: Amplified Tube Subwoofers 09-23-2014, 11:12 AM
Replies: 7
Views: 76
Posted By heavyduty
Re: Hoping someone can help me

No, that is not what happens. When the Tube is connected, and the vehicles system is turned on, the audio system is sensing an impedance issue with the subwoofer. As such, the system intially turns...
Forum: Amplified Tube Subwoofers 09-23-2014, 11:08 AM
Replies: 157
Views: 52,413
Posted By heavyduty
Re: FAST-9999 Installaton Instructions

The green LED should turn off when the vehicle is off. The green LED indicates that the turn-on circuit has power.
Forum: Amplified Tube Subwoofers 09-23-2014, 10:23 AM
Replies: 7
Views: 76
Posted By heavyduty
Re: Hoping someone can help me

No apologies needed. No one should ever give you a hard time for asking a valid question, especially if you are geniunely interested in learning. A LOC is a Line Output Converter. It takes the...
Forum: Amplified Tube Subwoofers 09-23-2014, 10:09 AM
Replies: 157
Views: 52,413
Posted By heavyduty
Re: FAST-9999 Installaton Instructions

Identify the constant +12v of the harness, as well as the switched +12v of the harness. Connect the red wire of the FAST to the constant +12v, and the blue/white wire of the FAST to the switched...
Forum: Amplified Tube Subwoofers 09-23-2014, 10:08 AM
Replies: 1
Views: 59
Posted By heavyduty
Re: is RCA sound quality same a rear speaker wire tap?

No, there will not be a gain in sound quality, in fact, there will most likely be a loss due to the 2.5v of the low level. Using high level outputs is using a VERIFIED high voltage signal, the...
Forum: Amplified Tube Subwoofers 09-23-2014, 09:59 AM
Replies: 7
Views: 76
Posted By heavyduty
Re: Hoping someone can help me

This may very well be an impedance issue. The fix is to install an LOC into factory subwoofer leads.
Forum: Amplified Tube Subwoofers 09-16-2014, 02:39 PM
Replies: 2
Views: 124
Posted By heavyduty
Re: Wire Size Issue

The amperage draw of the BTA Line is quite small, as such, the fuse holder with 18 gauge pigtails, attached to a 16 gauge or larger power wire (as directed in the manual), will have absolutely no...
Forum: Amplified Tube Subwoofers 09-10-2014, 12:50 PM
Replies: 3
Views: 156
Posted By heavyduty
Re: Low Level Input Question

No, you will need to purchase y-adapters to make the connection.
Forum: Amplified Tube Subwoofers 09-09-2014, 01:58 PM
Replies: 3
Views: 111
Posted By heavyduty
Re: Consant Even Volume

Please see my response to your other post.
Forum: Amplified Tube Subwoofers 09-09-2014, 01:57 PM
Replies: 8
Views: 2,362
Posted By heavyduty
Re: Jeep Wrangler

Great. After the connections are made, and IF, you run into the Tube powering on, followed by the entire system powering off, you will need to install an LOC to make the signal connections. Post...
Forum: Amplified Tube Subwoofers 09-09-2014, 12:28 PM
Replies: 9
Views: 354
Posted By heavyduty
Re: BTA8100 Assistance Needed

Contact Sonic Electronix and ask for a return authorization.
Forum: Amplified Tube Subwoofers 09-09-2014, 12:23 PM
Replies: 1
Views: 110
Posted By heavyduty
Re: Please help identify

That appears to be an A30.

http://www.bazooka.com/tech/wiring-diagrams/A-30

Here is your new harness;
...
Forum: Amplified Tube Subwoofers 09-09-2014, 12:20 PM
Replies: 3
Views: 111
Posted By heavyduty
Re: Consant Even Volume

I responded to your other post inquiring into where the connections were made before I read this post. Can you tell me what wires you connected to at the headunit?
Forum: Amplified Tube Subwoofers 09-09-2014, 12:18 PM
Replies: 3
Views: 226
Posted By heavyduty
Re: Volume Control - Factory 2006 Jeep Radio

Where have the FAST Harness connections been made?
Forum: Amplified Tube Subwoofers 09-09-2014, 12:17 PM
Replies: 8
Views: 2,362
Posted By heavyduty
Re: Jeep Wrangler

Where have you made all of the FAST Harness connections?
Forum: Customer Service 09-09-2014, 12:15 PM
Replies: 1
Views: 239
Posted By heavyduty
Re: VSE-SCI-145L-07 and RCA Scion XB2

My first question would be, why? And while I realize this sounds like a insincere, callous approach, it really is not. If your current subwoofer is working fine, then I ask, why all of the hassle?
Forum: Amplified Tube Subwoofers 08-04-2014, 08:30 PM
Replies: 9
Views: 354
Posted By heavyduty
Re: BTA8100 Assistance Needed

Where and when did you purchase the RBCM-100?
Forum: Amplified Tube Subwoofers 08-04-2014, 08:29 PM
Replies: 9
Views: 354
Posted By heavyduty
Re: BTA8100 Assistance Needed

The benefit is that you are connecting to a verified, switched +12v source. As for blown fuses, nothing to worry about. The switched remote circuit is measured in milli-amps. As long as you have...
Forum: Amplified Tube Subwoofers 07-31-2014, 03:55 PM
Replies: 9
Views: 354
Posted By heavyduty
Re: BTA8100 Assistance Needed

I should also add, disconnect your connections at the headunit, and make them at the output terminals of the amplifier. Disconnect the Auto-Turn On Loop, and connect to the remote terminal of the...
Forum: Amplified Tube Subwoofers 07-31-2014, 09:10 AM
Replies: 9
Views: 354
Posted By heavyduty
Re: BTA8100 Assistance Needed

Answer to question 1.) No, due to the size of the front speakers. Ideally, a 4x6 speaker is tuned to limit any bass frequency it cannot reproduce, which causes distortion. No bass information...
Forum: Amplified Tube Subwoofers 07-22-2014, 09:35 AM
Replies: 1
Views: 170
Posted By heavyduty
Re: C5 Corvette

It is a bit more complicated, but very possible. In this install, due to the unique voltage of the Bose System, the RCA's of the harness, either the FAST System, or the harness with a BTAXX100, will...
Forum: Amplified Tube Subwoofers 07-21-2014, 03:39 PM
Replies: 3
Views: 211
Posted By heavyduty
Re: Wiring Harness Diagram.....

Follow the instructions on the FAST-9999 installation sheet.

http://www.bazooka.com/pdf/current/FAST_9999_instr_rev1_sm.pdf
Forum: Amplified Tube Subwoofers 07-13-2014, 01:06 AM
Replies: 3
Views: 146
Posted By heavyduty
Re: Stock 2004 Toyota Matrix Stereo

Consult the owner's manual of your Pyle for installation requirements.
Forum: Amplified Tube Subwoofers 07-13-2014, 01:05 AM
Replies: 5
Views: 162
Posted By heavyduty
Re: Wire Gauge??

I have no idea, as you are using a Pyle component. I have no information on the unit. However, the owner's manual of the Pyle, should have an appropriate wire size to use.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -5. The time now is 10:54 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Template-Modifications by TMS
bazooka.com
SAS, BAZOOKA, BASS TUBES, and LISTEN TO YOUR EARS are registered trademarks of Southern Audio Services, Inc.