Club Bazooka

Club Bazooka (http://www.bazooka.com/forums/index.php)
-   Amplified Tube Subwoofers (http://www.bazooka.com/forums/forumdisplay.php?f=9)
-   -   need help. only have a serial # (http://www.bazooka.com/forums/showthread.php?t=8225)

chuckpt1979 02-18-2013 08:02 PM

need help. only have a serial #
 
I have an 04 dodge ram with an after market radio. This bazooka tube was given to me and I know it works. I wanna get it hooked up but have no wiring. Has no identification on it except it says sas bazooka with a number at the bottom g45a8c0025. I need to know what wiring harness I have to get. It doesn't have RCA plug ins like an amp and its either a 6in or 8in. Thats all i got. I can't hook it up until I know. Please help. :confused:

Geneh 02-19-2013 08:47 AM

Re: need help. only have a serial #
 
Is the connector a single row or double row?

chuckpt1979 02-19-2013 11:26 AM

Re: need help. only have a serial #
 
It has a double row of 7 equaling 14. To the right it has 2 knobs, below the connector is 2 fuses, and to the left is the positive and negative connectors. Hope that helps

heavyduty 02-19-2013 12:49 PM

Re: need help. only have a serial #
 
Quote:

Originally Posted by chuckpt1979 (Post 34233)
It has a double row of 7 equaling 14. To the right it has 2 knobs, below the connector is 2 fuses, and to the left is the positive and negative connectors. Hope that helps

It sounds as if you have the A80 model Tube.

http://store.bazooka.com/RSA-hp-AWK-...ubes-P298.aspx

chuckpt1979 02-19-2013 01:54 PM

Re: need help. only have a serial #
 
that looks exactly like it. Thanks. Now I can order the wiring and get it hooked up. I hope it has a good amount of watts.

heavyduty 02-19-2013 02:11 PM

Re: need help. only have a serial #
 
Quote:

Originally Posted by chuckpt1979 (Post 34235)
that looks exactly like it. Thanks. Now I can order the wiring and get it hooked up. I hope it has a good amount of watts.

80 watts at 4 ohms and 120 watts at 2 ohms. The A80 can drive a passive Tube, also known as a slave unit. You can also swap the original driver out for a DVC 4 ohm version. Wire the voice coils in parallel, leave the High Level Output wires alone and the amplifier is operating at 2 ohms mono.


All times are GMT -5. The time now is 05:16 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
bazooka.com