Club Bazooka

Club Bazooka (http://www.bazooka.com/forums/index.php)
-   Customer Service (http://www.bazooka.com/forums/forumdisplay.php?f=22)
-   -   Scion iQ (http://www.bazooka.com/forums/showthread.php?t=7991)

Bohemian 06-14-2012 10:52 AM

Scion iQ
 
Noticed you have a few Scion specific products. Are/Will there be anything for the new iQ model?

Geneh 06-14-2012 10:58 AM

Re: Scion iQ
 
No, at this time there is no plans on making any future OEM products. If you are looking for bass you can use one of our amplified Bazooka Tubes.

Bohemian 06-14-2012 12:36 PM

Re: Scion iQ
 
The Scion iQ is very small, near Smart Car small. What would be the smallest powered sub?

heavyduty 06-14-2012 02:20 PM

Re: Scion iQ
 
Quote:

Originally Posted by Bohemian (Post 33650)
The Scion iQ is very small, near Smart Car small. What would be the smallest powered sub?

The 6" Tube. Check out the BTA6100 or the BTA6250D.

Bohemian 06-14-2012 03:27 PM

Re: Scion iQ
 
Thanks, one last question.

What FAST connector would I use? FAST-1761?

I have the Premium audio and it is a Pioneer ADCP-W12U T1818 Toyota part # PT546-00121
I would think the connectors are the same as the stock radio.

Bohemian 06-14-2012 04:05 PM

Re: Scion iQ
 
Or am I reading that no FAST connectors work with the BTAx250 series? So is there an install kit needed/required or is all included and I just have to splice into wires?

heavyduty 06-14-2012 04:44 PM

Re: Scion iQ
 
Quote:

Originally Posted by Bohemian (Post 33653)
Or am I reading that no FAST connectors work with the BTAx250 series? So is there an install kit needed/required or is all included and I just have to splice into wires?

That is correct, the FAST Harness System is not compatible with the 250D line. You will need to purchase an amplifier installation kit to complete the install. You will want to identify a switched +12v source for the remote turn-on connection as well as the correct wires for creating a signal source. You can connect to the factory speakers and use the Tube's High Level Inputs or install an LOC and connect the Tube using the Low Level Inputs.

Look for a LOC such as the PAC SNI-45T (High Power 2-Channel Line Output Converter with Low Voltage Trigger Remote). With going this route you will no longer need to identify the factory switched +12v source, just connect the remote turn-on connection of the Tube to the remote wire of the LOC.


All times are GMT -5. The time now is 03:36 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
bazooka.com