Club Bazooka

Club Bazooka (http://www.bazooka.com/forums/index.php)
-   Amplified Tube Subwoofers (http://www.bazooka.com/forums/forumdisplay.php?f=9)
-   -   On/off pattern (http://www.bazooka.com/forums/showthread.php?t=7511)

genau 02-02-2012 08:09 PM

On/off pattern
 
I recently purchased a: Bazooka BTA6100 BT Series 6-Inch 100-Watt Amplified Tube Subwoofer.


I installed it, in two different vehicles and in both of the vehicles it does the following: It powers on, and works for about 2 minutes, then it turns off, and then after about 2 seconds or so it powers back on. This pattern continues indefinitely.

FYI: I have it hooked up without the remote lead, with the harness/clip that came with the tube and I am using only the RCA outputs of the head unit as the sound input into the tube.

Does anyone have any ideas?

genau 02-03-2012 11:51 AM

Re: On/off pattern
 
I had wanted to add that I am using the low level inputs from this head unit, these are the specs of the unit:

http://www.alpine-usa.com/product/view/ida-x303/Specs

heavyduty 02-03-2012 06:07 PM

Re: On/off pattern
 
Quote:

Originally Posted by genau (Post 32731)
I had wanted to add that I am using the low level inputs from this head unit, these are the specs of the unit:

http://www.alpine-usa.com/product/view/ida-x303/Specs

Check your ground to begin with. If the ground is good, disconnect the Auto-Turn On Loop and connect the remote turn-on wire of the Tube to the amplifier remote of the headunit. If you are still having the same problem, connect the remote turn-on of the Tube to the +12v constant power supply and see if the problem continues to exist.


All times are GMT -5. The time now is 04:33 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
bazooka.com