Originally Posted by minshik (Post 30460)

I have a 2009 Honda Fit with the factory HU and I have used a FAST connector to connect the sub to the HU. I believe the wiring is correct, but when I turn on the ignition, the green indicator light flickers and then turns off. The sub does not work. Any thoughts?

Originally Posted by heavyduty (Post 30466)

Welcome to the Bazooka Forum. Check your ground connection, make sure that the surface has been properly prepared and securely fastened.

Originally Posted by minshik (Post 30468)

I checked the ground connection and all other connections with a meter. All levels say that it's ok. Are there any other options? Could it be that the subwoofer is defective?

Originally Posted by heavyduty (Post 30469)

Did you measure your resistance at ground? If your using the FAST-9999 make sure that all connections at the headunit are tight and secure.

Originally Posted by minshik (Post 30472)

Yes I measured the resistance at ground. i checked all the connections at the HU and they are all in contact.

Originally Posted by heavyduty (Post 30474)

What color are the wires you are connecting to at the factory harness?

Originally Posted by minshik (Post 30480)

FAST-----------------HU

red-------------------orange (accessory)
blue/white-----------black (power antenna)
white-----------------light blue (front left +)
white/black-----------light green (front left -)
gray-------------------brown (front right +)
gray/black-------------red (front right -)

this is how I connected the wires.

Originally Posted by heavyduty (Post 30481)

Switch the blue/white to the orange wire of the factory harness. Keep the red wire connected to the same orange wire.